How to do the technology and quality of outdoor line lights should be done well

As a kind of led outdoor lighting products, outdoor line lights are important to do a good job of waterproof, because the outdoor conditions are harsh, requiring outdoor line lights to do well in terms of technology and quality, so how to do it?

Many outdoor products require waterproof, such as outdoor line lights, led wall washing lights, led guardrail tubes, led point light sources, led floodlights, led outdoor lighting fixtures, car lights, waterproof watches, aquarium products, underwater cameras, and so on, as well as special industries.

The diameter of the water molecule is about 0.4MM, which is larger than the capillary gap of the aperture of the scale, and the water can pass through. The diameter of the water molecule is slightly larger than the diameter of the gas molecule, and the gas can pass through the hole of 0.27 to 0.39MM.

The two concepts of sealing and waterproofing are actually similar, but the focus is not the same. Waterproof focus is "not allowed to come in", to avoid the intrusion of external water or water vapor medium, penetration, inflow.

Once the electrical goods are flooded, there may be many problems such as short circuit, leakage, rust, decay, damage media prices, interference signals and so on. Therefore, waterproof usually means to prevent the water or water vapor outside the electrical appliance from invading, soaking, and flowing into the electrical appliance.

More time, we need to use sealing methods, structural methods, material selection, etc., to ensure long-term effective waterproof products, learn traditional, classic, sophisticated sealing skills or techniques to enhance the waterproof performance of led outdoor lighting products.

For outdoor line light products, waterproof and sealing should be done, so as to ensure the normal use of led lighting products, if there is water and air leakage found, should stop using, after all, the product is changed, the use will have a certain impact.

1. After gluing, due to improper handling or wrong position during gluing, it should be disassembled and regluing.

2. The light source components need to be disassembled and analyzed when anti-repair led buried lights, led underwater lights, led wall washing lights, outdoor line lights and so on are filled with glue and waterproof.

3, anti-lumen, COB and other light source poor analysis may need to remove the original package of soft glue or stone hard glue.

4, waterproof power supply, light source module scrapped after recycling of the valuable parts.

5, in the inspection, test, product certification, engineering acceptance or production process confirmation of the necessary stripping analysis.

6, the outdoor line lamp and wall washing lamp stripping methods are knocking vibration method, stripping method, moment method, heating method, solvent method, soaking method, alkali hydrolysis method, etc.